হোয়াটসঅ্যাপ:+8613388587272

ই-মেইল:[email protected]

en.pngEN
সব ধরনের
পার্শ্ববর্তী

ড্রোনের বিভিন্ন জিনিসপত্র

মূল পাতা>পণ্য>ড্রোনের বিভিন্ন জিনিসপত্র

পণ্য

SB_WING-MINI-7__57884
SB_WING-MINI-5__86020
SB_WING-MINI-6__32244
SB_WING-MINI-4__69464
SB_WING-MINI-1__04828
SB_WING-MINI-7__57884
SB_WING-MINI-5__86020
SB_WING-MINI-6__32244
SB_WING-MINI-4__69464
SB_WING-MINI-1__04828

নতুন আগমন: SpeedyBee F405 WING MINI ফিক্সড উইং ফ্লাইট কন্ট্রোলার

বৈশিষ্ট্য:
তদন্ত
বর্ণনাঃ
গুরুত্বপূর্ণ তথ্যাবলী
পণ্যের নাম SpeedyBee F405 WING MINI FC board
MCU STM32F405, 168MHz, 1MB Flash
আইএমইউ (গাইরো এবং অ্যাক্সিলোমিটার) ICM-42688-P
আবহমানযন্ত্র SPL006-001
ওএসডি চিপ AT7456E
কালো বাক্স মাইক্রোএসডি কার্ড স্লট
UART 6 sets (USART1, USART2, USART3, UART4, UART5,
UART6 - Dedicated for Wireless board Telemetry connection)
I2C 1x ম্যাগনেটোমিটার, ডিজিটাল এয়ারস্পিড সেন্সরের জন্য ব্যবহৃত
এডিসি 4x (VBAT, Current, Analog RSSI, Analog AirSpeed)
PWM 12x (9x pin headers + 2x solder pads + 1x "LED" pad)
ELRS/CRSF Receiver Supported, connected to UART1
এসবিএস Built-in inverter for SBUS input (UART2-RX)
এলইডি 3x LEDs for FC STATUS (Blue, Green) and 3.3V indicator (Red)
Analog RSSI Supported, Named as "RS"
Dual Analog Camera Switching Default to Camera1 Video Input (C1). Switch between C1 and C2 using ArduPilot Relay or INAV Modes/USER.
Both cameras should have the same video format, either PAL or NTSC.
সমর্থিত এফসি ফার্মওয়্যার INAV: SpeedyBeeF405WING (default)
ArduPilot: SpeedyBeeF405WING
ওজন 5.6g
 
পণ্যের নাম SpeedyBee F405 WING MINI PDB board
ইনপুট ভোল্টেজ পরিসীমা 7~26V (2~6S LiPo)
ব্যাটারি ভোল্টেজ সেন্সর Connect to FC board VBAT, 1K:10K (Scale 1100 in INAV, BATT_VOLT_MULT 11.0 in ArduPilot)
ব্যাটারি কারেন্ট সেন্সর 80A continuous, 150A peak Connect to FC board Current (Scale 195 in INAV, 50 A/V in ArduPilot)
টিভিএস প্রতিরক্ষামূলক ডায়োড হাঁ
FC BEC আউটপুট Output 5.2V +/- 0.1V DC Continuous current 2 Amps, 3A Peak Designed for FC, Receiver, GPS module, AirSpeed Sensor, Telemetry module
VTX & Camera power supply The VTX power interface Vv offers two power supply options: direct battery voltage or integrated BEC 5V (sharing the 5V4A Servo BEC voltage)
By default, it is set to battery voltage
(Ensure the VTX and camera input voltage range is compatible)
Switching to 5V power supply is possible via pad jumper (using Servo BEC output)
(If using this method, ensure the current requirements for both servo and VTX are sufficient)
সার্ভো বিইসি আউটপুট Output 5V +/- 0.1V DC Continuous current 4 Amps, 5A Peak Voltage adjustable, 5V Default, 6V via jumper Designed for Servos.
ওজন 5.5g
 
পণ্যের নাম SpeedyBee F405 WING MINI Wireless USB Extender
ওয়্যারলেস কনফিগারেশন (মোড স্যুইচ করতে 6 সেকেন্ডের জন্য বুট বোতাম দীর্ঘক্ষণ টিপুন)
INAV:Please make sure the MSP switch on UART 6 is turned on and set to a baud rate of 115200 ArduPilot:Please make sure the Serial 6 is set to baud rate 115200 and protocol Mavlink2
BLE মোড, Speedybee APP এর সাথে সংযোগ করুন
Wi-Fi (AP)mode, able to connect to Speedybee APP, QGroundControl APP, MissionPlanner, etc. WiFi: Speedybee eFLY-WIFI Password: 88888888
Wi-Fi (STA)mode, able to connect to QGroundControl APP, MissionPlanner, etc.
Step 1: turn on Personal Hotspot;
Step 2: Set hotspot, locate NAME/Device Name/Hotspot name/etc.
Step 3: change the current name to eFLY and the password is, 88888888
Wireless off mode
ইউএসবি পোর্ট প্রকার প্রকার-সি
হর্ণ 5V Active Buzzer
ওজন 3.2g


যোগাযোগ করুন

হট বিভাগ